When drawing wires that cross one another in a schematic it would be useful to show a bridge so they are not confused with connected wires.
I have made a "bridge" component which looks OK on a schematic but it may have implications in the PCB layout in that the PCB would have to have an actual bridge (two holes with a piece of wire between them) on it.
When drawing wires that cross one another in a schematic it would be useful to show a bridge so they are not confused with connected wires.
I have made a "bridge" component which looks OK on a schematic but it may have implications in the PCB layout in that the PCB would have to have an actual bridge (two holes with a piece of wire between them) on it.
Kind regards,
Roger