Print middle layers with plus (1 reply and 1 comment)
You can print the inner layers by turning the other layers off on your design the select Print then Print As Displayed.
Thank you. That worked but it is still a bit clunky compared to the simplicity of the original program.
I'm finding out that for all the good new features in Plus it's missing an essential piece I use quite a lot. It doesn't print the internal layers. I use a lot of shielding and guarding and use ACD Canvas for graphics so aside from the ability to check routing from a printout there is a feature in Canvas that allows Canvas to act as a printer. I use this to input dimensionally accurate drawings of the PCB layers into mechanical drawings. It works perfectly in ExpressPCB classic. The print options in Plus are quite primitive and far too limiting for me. Will the ability to individually print all layers be added to Plus in the near future?