Connect error (1 reply and 3 comments)
Accepted answer
Hi Andrea,
Do you have a pin on the component where you are trying to connect the wire?
Does both sides need pins? I have a pin connected to the body of the component
I got it ... the pin was on the wrong end, it is supposed to be on the side furthest away from the part body
Good to hear you got it!
When I run the Checking Schematic for netlist errors, I get the error "The selected corner is only connected to one wire. This indicates a wire that is not properly connected at both ends ... Check the wire and either delete it or drag the wire's end to the desired connection point (either a corner or component pin)"
I'm trying to connect a wire to a custom made component. No matter what I try, nothing seems to work - how do I create a connection to the component?
Thanks,
Andrea